RPM and TWAMP

These devices fully support Real-time performance monitoring (RPM) and Two-Way Active Measurement Protocol (TWAMP):

• You can configure RPM probe generation, reception, and reflection and enable timestamps on RPM probe messages.
• You can also use RPM probes to detect link status and to change the preferred-route state on the basis of the probe results. RPM-tracked routes can be IPv4 or IPv6, and support up to 16 next hops for each IPv4 or IPv6 RPM-tracked static route. You can configure route preference and tag values for each IPv4 or IPv6 destination prefix.
• You can also configure RPM services to automatically determine whether a path exists between a host device and its configured BGP neighbors. You can view the results of the discovery using an SNMP client. The results are stored in pingResultsTable, jnxPingResultsTable, jnxPingProbeHistoryTable, and pingProbeHistoryTable.
• For TWAMP, we support IPv4 and IPv6 (including link-local addresses) traffic for control sessions and test sessions. We support TWAMP for IPv4 and IPv6 traffic, including link-local addresses, for control sessions and test sessions.
• For TWAMP Light, we support IPv4 and IPv6 traffic, including IPv6 link-local addressing.