TE Options : bgp-igp-both-ribs

When you configure an LSP, a host route (a 32-bit mask) is installed in the ingress router toward the egress router; the address of the host route is the destination address of the LSP. The bgp option for the traffic-engineering statement at the [edit protocols mpls] hierarchy level is enabled by default (you can also explicitly configure the bgp option), allowing only BGP to use LSPs in its route calculations. The other traffic-engineering statement options allow you to alter this behavior in the primary routing instance. This functionality is not available for specific routing instances. Also, you can enable only one of the traffic-engineering statement options (bgp, bgp-igp, bgp-igp-both-ribs, or mpls-forwarding) at a time. VPNs require that routes remain in the inet.3 routing table to function properly. For VPNs, configure the bgp-igp-both-ribs option of the traffic-engineering statement to cause BGP and the IGPs to use LSPs for forwarding traffic destined for egress routers. The bgp-igp-both-ribs option installs the ingress routes in both the inet.0 routing table (for IPv4 unicast routes) and the inet.3 routing table (for MPLS path information).